Did It (almost) All By Myself Aug 15, 2016

I recently purchased the MXZ-2C20NAHZ along with the 12K and 9K floor mounted indoor units. I also purchased two Mitsubishi line sets, wall brackets, disconnect switch and drain tubing. All items were received with very quick shipping and no issues or delays. I installed all items with the exception of the line sets myself. I mounted the outdoor unit, indoor units, installed a new floor drain in my attic to collect condensation, made a new 220 line with disconnect and ran the 14/4 cables to... more

Crown Boiler Awr038 - 32k Btu - 83.0% Afue - Hot Water Propane Boiler - Chimney Vent Review Aug 15, 2016

Installed this boiler in June 2012 - Very good documentation - Very good response from customer service when I had a question about the controls. Checked on higher efficiency rated boilers but could not justify the much higher price. Until you make up the increase in price with the savings in fuel the unit would be 8 - 10 years old. By then you would probably have maintenance problems and just check the prices on parts for the higher efficiency boilers (parts prices are very high compared... more

Warmwire Heated Floor Apr 20, 2016

I installed a WarmWire heated floor in a 6'x8' coat room that had no other source of heat. It is on a concrete slab with 2 outside walls and a wall to an unheated attached garage. I glued 2 6mm thick sheets of Cerazorb synthetic cork directly on the concrete. It was super easy to lay the wire on top on the cork using the metal clip system provided. To be safe, I laid a sheet of 1/4" luan plywood on top of the wires while laying the tile. I checked the resistance in the wires at each step... more

Burnham 206i - 135k Btu - 82.0% Afue - Hot Water Gas Boiler - Chimney Vent Review Jul 25, 2016

I have many years of good service with this boiler on propane, and never needed service.

Love Is Fantech Sep 28, 2016

I used this inline fan to hook up to my vent hood in my kitchen. Even though this product was assembled in America, the motor was made in Germany and you certainly can't go wrong with German technology. I also brought LD10 silencer to attach directly to the fan and placed the silencer between the vent hood and the fan. I also purchased the FC10 clamp to hold the silencer and fan in place. I find the clamp itself was not good enough to hold fan and the silencer. To give me a piece of mind,... more